Komatsu — VARIABLE BLADE

EXPLANATION OF COMPONENTS OPERATION This lever (10) switches between the variable gauge and blade control. Lever control Direction of operation (a) RAISE Variable gauge (b) LOWER Blade For details of the method of operating the variable gauge and blade, see the section on the "BLADE CONTROL/VARIABLE GAUGE LEVER (PAGE 3-13)". VARIABLE BLADE NOTICE G Use the same width for the variable gauge and blade. G Operate the variable blade only when the variable gauge is fully retracted. If the variable blade is operated when the variable gauge is extended, the blade will contact the rubber shoe and stop it from rotating.

G Setting blade to minimum width Remove pin (1), turn blade (2) to align pin hole (3) and the hole in blade (2), then insert pin (1) again. G Setting blade to maximum width Remove pin (1), turn blade (2) to align pin hole (3) and the hole in blade (2), then insert pin (1) again. 3-16