5. Fuel Level Indicator - Indicates approximate amount of gasoline in the gas tank. 11. Speedometer - Indicates the approxi- mate vehicle speed in miles per hour (MPH) or kilometers per hour (km/h). „ NOTE: When the bottom seg- ment flashes, approximately 3.8 L (1.0 U.S. gal.) of gasoline remains in the tank. „ NOTE: To change mph/km/h dis- play, press and release Mode But- ton (3) until the icon (MPH/km/h) appears; then press the Set Button (4) to change the display. 6. Odometer/Trip Meter - Odometer registers the total distance the vehicle has traveled. The trip meter is resetable and can be used to measure trip or trip legs. The odometer cannot be reset.
Condition Warning Display - Uses odome- ter/trip meter display of the LCD to warn of a system error condition requiring attention. A. Volt - The LCD will go blank except the word VOLT will flash on the LCD whenever a low volt- age ( age (> 16 DC volts) is detected. When voltage returns to normal, the gauge must be reset by turning the ignition key to the OFF posi- tion and then to the ON position. „ NOTE: To shift between the odom- eter (ODO) or trip meter (TRIP), press the Mode Button (3) to select the distance mode; then press the Set/Reset Button (4) to select the desired display. Hold the Set/Reset Button down to reset the trip meter. B.
EFI - The LCD will go blank except the letters EFI will flash on the LCD whenever an electronic fuel injection error is detected. After 30 seconds, the LCD will return to normal; however, the let- ters EFI will continue to flash until the cause of the error is corrected. „ NOTE: Take the vehicle to an autho- rized Arctic Cat dealer to have the error corrected and to have the sys- tem error reset as soon as possible. HDX192B 7. Gear Position Indicator - Indicates which gear position is selected. Electric Fuel Pump An electric fuel pump is mounted in the gas tank to deliver gasoline to the fuel injector. The fuel pump operates when the ignition switch is turned to the ON or START position.
R (reverse)/N (neutral)/L (low range)/ H (high range) „ NOTE: An E will be displayed if there is an error caused by a no- shift position signal. 8. High Beam Indicator - The High Beam icon will appear only when the headlights are on high beam. Gas Hoses Replace the gas hose every two years. Dam- age from aging may not always be visible. 9. 4WD Lock Indicator - Displays LOCK when the front differential lock has been engaged. Oil Level Stick There is an oil level stick for checking the engine oil level. To check the oil level, use the following procedure. 10. Drive Select Indicator - Displays 4WD when selected by the drive select switch or when the 4WD lock is engaged.
The display is blank when in 2WD. „ NOTE: The vehicle should be on level ground when checking the engine oil level. 32