3. Connect the red terminal lead from the charger to the positive terminal of the battery; then connect the black terminal lead of the charger to the negative terminal of the battery. 4. Plug the charger into a 110-volt elec- trical outlet. 5. By pushing the Mode button (A) on the left side of the charger, select the Nor- mal Charge Icon (E). The Normal Charge Indicator (C) should illuminate on the upper left portion of the charger. 800E „ NOTE: The maintainer/charger will charge the battery to 95% capacity at which time the Mainte- nance Charge Indicator (D) will illu- minate and the maintainer/charger will change to pulse/float mainte- nance.
If the battery falls below 12.9 DC volts, the charger will automati- cally start again at the first step of the charge sequence. 6. The battery will charge to 95% of its capacity at which time the Mainte- nance Charge Indicator (D) will illu- minate. „ NOTE: For optimal charge and per- formance, leave the charger con- nected to the battery for a minimum 1 hour after the Maintenance Charge Indicator (D) illuminates. If the bat- tery becomes hot to the touch, stop charging. Resume after it has cooled. 7. Once the battery has reached full charge, unplug the charger from the 110-volt electrical outlet. „ NOTE:
If, after charging, the bat- tery does not perform to operator expectations, bring the battery to an authorized Arctic Cat dealer for further troubleshooting. 3300A „ NOTE: Not using a battery char- ger with the proper float mainte- nance will damage the battery if connected over extended periods. Jump-Starting „ NOTE: Arctic Cat does not recom- mend jump-starting a vehicle with a dead battery but rather to remove the battery, service it, and correctly charge it; however, in an emergency, it may be necessary to jump-start a vehicle. If so, use the following procedure to carefully and safely complete this procedure. Charging „ NOTE:
Arctic Cat recommends the use of the CTEK Multi US 800 or the CTEK Multi US 3300 for battery maintenance charging. 1. Be sure the battery and terminals have been cleaned with a baking soda and water solution. ! WARNING 2. Be sure the charger and battery are in a well-ventilated area and ensure the battery charger cables will not contact any battery acid. Be sure the charger is unplugged from the 110-volt elec- trical outlet. Improper handling or connecting of a battery may result in serious injury including acid burns, electrical burns, or blindness as a result of an explosion. Always remove rings and watches. 1.
On the vehicle to be jump-started, remove the battery cover and any ter- minal boots. 44