3. Using the measurements obtained in step 2, make horizontal marks on the aiming surface. CAUTION When replacing the headlight bulb, be careful not to touch the glass por- tion of the bulb. Grasp the new bulb with a clean cloth. 4. Make vertical marks which intersect the horizontal marks on the aiming surface directly in front of the head- lights. To replace the taillight/brakelight bulb, use the following procedure. 5. Switch on the lights. Make sure the HIGH beam is on. DO NOT USE LOW BEAM. 1. Remove the mounting screws secur- ing the taillight/brakelight assembly to the rear canopy tube. 2. Rotate the socket counterclockwise and remove it from the housing. 6.
Observe each headlight beam aim. Proper aim is when the most intense beam is centered on the vertical mark 5 cm (2 in.) below the horizontal mark on the aiming surface. 3. To remove the bulb from the socket, pull it straight out of the socket. 4. To install the bulb, push it straight into the socket. 7. Adjust each headlight until correct aim is obtained, by turning the knob clockwise to raise or counterclock- wise to lower the beam. 5. Insert the socket into the housing and rotate it clockwise. 6. Position the taillight/brakelight assem- bly on the rear canopy tube; then tighten the mounting screws securely.
DIVISION II - OPERATION/ MAINTENANCE Checking/Adjusting Headlight Aim The headlights can be adjusted vertically and horizontally. The geometric center of the HIGH beam light zone is to be used for vertical and horizontal aiming. 1. Position the vehicle on a level floor so the headlights are approximately 6.1 m (20 ft) from an aiming surface (wall or similar aiming surface). Fuses The fuses are located in a power distribu- tion module under the driver seat. If there is any type of electrical system failure, always check the fuses first. CD714A „ NOTE: To remove the fuse, com- press the locking tabs on either side of the fuse cover and lift out. XT „ NOTE:
There should be an aver- age operating load on the vehicle when adjusting the headlight aim. 0740-647 2411-080 2. Measure the distance from the floor to the mid-point of each headlight. 49