Preparation For Storage Arctic Cat recommends the following procedure to prepare the vehicle for stor- age. An authorized Arctic Cat dealer should perform this service; however, the owner/operator may perform this service if desired. 4. Plug the hole in the exhaust system with a clean cloth. 5. Apply light oil to the upper steering shaft bushing and plungers of the shock absorbers. CAUTION 6. Tighten all nuts, bolts, cap screws, and screws. Make sure rivets holding components together are tight. Replace all loose rivets. Care must be taken that all calibrated nuts, cap screws, and bolts are tightened to specifications.
Prior to storing this vehicle, it must be properly serviced to prevent rust- ing and component deterioration. 1. Clean the seat cushions with a damp cloth and allow to dry. 2. Clean the vehicle thoroughly by washing dirt, oil, grass, and other for- eign matter from the entire vehicle. Allow the vehicle to dry thoroughly. DO NOT get water into any part of the engine or air intake. 7. Fill the cooling system to the bottom of the stand pipe in the radiator neck with properly mixed coolant. 8. Disconnect the battery cables (nega- tive cable first); then remove the bat- tery, clean the battery posts and cables, and store in a clean, dry area. 3.
Either drain the gas tank or add a fuel stabilizer to the gas in the gas tank. Remove the air filter housing cover and air filter. Start the engine and allow it to idle; then using Arctic Cat Engine Preserver, rapidly inject the preserver into the air filter opening for a period of 10 to 20 seconds. Install the air filter and housing cover. „ NOTE: For storage, use a battery maintainer or make sure the battery is fully charged (see Battery section in this manual). 9. Store the vehicle indoors in a level position. CAUTION CAUTION Avoid storing outside in direct sun- light and avoid using a plastic cover as moisture will collect on the vehicle causing rusting.
If the interior of the air filter housing is dirty, clean the area before starting the engine. 51