. OPERATION MACHINE OPERATIONS AND CONTROLS (C) Adjusting seat tilt Forward tilt Adjust the 3 - 82 Push lever (3) down to ad just angle of the front of seat. (4 stage To raise the angle at fr ont of the seat, keep the lever pushed down and appl y your weight t o the rear of s eat. To lower the angle at fr ont of the seat, keep the lever pushe d down and appl y your weight t o the front of seat. Rear tilt angle of the rear of seat. (4 stages) Pull lever (4) up to adjust To raise the angle at re ar of the seat, keep lever (3) pulled up , and s tand up s lightly to r emo ve your weigh t from the seat. ear of the seat, keep lever (3) pulled up, and apply your weight to the seat.
wn 13° To lower the angle at r ear of the seat, keep lever (3) pulled u p, and apply yo ur weight to the sea Amount of tilt: Up 13°, do Adjusting seat height seat up or down by combining adjustments forward tilt and rear tilt. It is possible to move the seat up or down by combining adjustments f orward tilt and rear After setting the forward til t or rear tilt to the desired height, oper ate the opposite part to se t the seat horizont al then secure in position. (2.4 in) Height adjustment: 60 mm (D) Adjusting armrest ang le to spring up by hand approx. 90°. Armrest (5) can be made to spring up by hand approx.
90° In addition, by turning the bottom (6) of the armrest by hand it is possible to ma ke fine vertical adjustments of the armrest angle. : 25°. Armrest adjustment angle REMARK If the seat back is tipped t o the front without raising the armrest( 5), armrest will (E) Overall fore-and-aft ad justment of seat Move lever (7) to right, set to the desired position, then release t he lever. In this case, the operator' s seat, le ft and right control levers, and lo ck lever all slide together.
80 mm (7.1 in) (9 stages) Fore-and-aft adjustment:1 (F) Adjusting suspension to make the suspension harder,or to the left to make the suspensio Turn knob (8) to the right reading of the dial to matc h the operator's weight and select the optimum suspe nsion. REMARK To obtain the optimum adj ustment, turn the knob (8) so that the in dicato r of the we ight display (kg ) in t he transparent portion of knob (8) is the s ame as the operator's weight.