Komatsu — TRAVELING ON SLOPES

. OPERATION MACHINE OPERATIONS AND CONTROLS TRAVELING ON SLOPES WARNING Turning or operating the work equipment when working on slopes may cause the machine to lose its balance and turn over, so avoid such 3 - 113 operations. Itis particularly dangerous to sw If such operations have to be ca ing downhill when the bucket is loaded. rried out, pile soil to make a platform on the slope so that the machine c an be kept horizontal when operati ng. Do not travel up or down steep s lopes. There is danger that the machine may turn over. When traveling, raise the bucke t approx. 20 to 30 cm (8 to 12 in) from the ground. e. cross slopes. to perform these operations.

It may be Do not travel downhill in revers Never turn on slopes or travel a Always go down to a flat place longer, but it will ensure safety Always operate or travel in suc at any time if the machine slips When traveling uphill, if the sho . h a way that it is possible to stop safely or becomes unstable. es slip or it is impossible to travel uphill using only the force of the track s, do not use the pulling force of the arm to help the machine travel uphil l. There is danger that the machine may turn over. 1. When traveling down stee p hills, use the travel lever and fuel control lever to keep the tr When traveling down slop equipment in the posture s lower the engine speed. avel speed low.

es of more than 15°, set the work work hown in the figure on the right, and REMARK cket side down. ith the sprocket side up, the track Travel down hills with the spro I f t he machine travels down w rack tends to become loose, and th at can cause skipping pitches. 2. When traveling up a steep hill of more than 15°, set the work equipment to the posture s hown in the diagram on the rig ht.