Komatsu — AFTER COLD WEATHER SEASON

. OPERATION COLD WEATHER OPERATION AFTER DAILY WORK COMPLETION WARNING 3 - 133 Performing idle-r unning of the tracks is dange rous, stay well away from the tra To prevent mu d, water, or the undercarria ge from freezing and making i t impossible f or the ma chine t o move o n the following morni ng, observe the following precautions. e machine body. In particular, wipe the hydraulic cylinder rods clean to Remove all the mud and water from th e machine body. In particula ylinder rods cle an to prevent dam age to the seal caused by mud, dirt, or drops of water o n the rod from getting inside the s eal. Park the ma chine on hard, dry ground.

I f this is imp ossible, park the machine The boards prevent the tracks from free zing to the ground, and allow the machine t o be mov ed the next morning. Open the dr ain valve and drain any wa ter collected in the fuel syste m to prevent i t from fre ezing. Fill the fuel t ank to capacity. This mini mizes moisture condensation in the tank wh en the te mperature d rop After operati on in water or mud, remov e water from undercarriage a s described b elow to e xtend undercarriage service life. 1. Swing 90° with engine at low idle and bring the work equipment to the side of the track. 2. Jack up the machine until the track is raised slightly from the ground. Rotate the track under no load.

Repeat this procedure on both the left and right sides. service life. 1. Swing 90° with engine at low idle and b to the side of the track. e machine until the track is 2. Jack up th tate the track under no loa AFTER COLD WEATHER SEASO N er becomes warmer, do as follows. ed fuel and oil. AND COOLANT SPECIFICATIONS (PAGE 4-10)". e cannot be used, and an ethylene glycol base antifreeze (winter, one When the seas on changes and the weath er becomes warmer, do as f Replace all f uel and oil with the specifi For details, see "LUBRICANTS, FUEL AND COOLANT SPECIFICA TIONS (PAG E 4-10)".

I f for any re ason permanent antifreez e cannot be used, and an et hylene glycol base an tifreez season type ) is used instead, or if no a ntifreeze is used, drain the c ooling system complet ely. Thoroughly flush out the cooli ng system and fill it with fr esh coolant.