. OPERATION TROUBLES AND ACTIONS DISCHARGED BATTERY WARNING 3 - 138 It is dan gerous to charge a battery whe n mounted on a machine. Make sure th at it is dismounted before charg ing. y, stop the engine and turn the . When c hecking or handling the batter starting switch key to the OFF position The bat tery generates hydrogen gas, s o there is a hazard of explosion. Do not bring lighted cigarettes near the battery, or do anything that wil cause s parks. Battery electrolyte is dilute sulfuric aci d, and it will attack your clothes and ski n. If it gets on your clothes or o n your skin, immediately wash it off with a large amount of water.
If it ge ts in your eyes, wash it out with fresh w ater and consult a doctor. handling batteries, always wear safety glasses and rubber When gloves. When r emoving the battery, first disconnect the cable from the ground (norma lly the negative (-) terminal). Wh en installing, install the positive (+) term inal first. If a tool touches the positive terminal a nd the chassis, there is danger that it w ill cause a spark, so be extrem ely careful. If the te rminals are loose, there is dange r that the defective contact may generat e sparks that will cause an expl osion. When r emoving or installing the termin als, check which is the positive (+) term inal and which is the negative ( -) terminal.
Battery Removal and Installation ve the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remo ve the ground cable (normally connected to the negative (-) If any t ool touches between the po sitive terminal and the chassis, there is a hazard of sparks being generated. When installing the battery, conne ct the ground cable last. battery securely in position with the battery mounting clamp. : 9.8 to 19.6 Nm (1.0 to 2.0 kgm, 7.2 to 14.5 lbft) When replacing the battery, fix the battery securely in position with the batte ry mounting clam Tighte ning torque of mounting bolt : 9.8 to 19.6 Nm (1.0 to 2.0 kgm, 7.2 to 1