Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Starting Engine with Booster Cables When starting the engine with a booster cable, do as follows. Connecting and Disconnecting Booster Cables WARNING booster cable, always wear safety structure frame), a spark will be spot as far away from the battery as exercise good care so that the each other, or they contact the Booster Cable Connection Keep the starting switch of the normal machine and problem machine in the OFF position. Connect the booster cable as follows, in the order of the numbers marked in the diagram. 1. Make sure the starting switches of the normal machine and problem machine are both at the OFF position. 2.

Connect one clip of booster cable (A) to the positive (+) terminal of the problem machine. 3. Connect the other clip of booster cable (A) to the positive (+) terminal of the normal machine. 4. Connect one clip of booster cable (B) to the negative (-) terminal of the normal machine. 5. Connect the other clip of booster cable (B) to the upper structure frame of the problem machine. 3 - 140 When connecting the cables, neve (-) terminals. When starting the engine with a glasses. Be careful not to let the normal m each other.

This prevents sparks fr could ignite the hydrogen gas giv explodes, it could cause serious i Be careful not to make a mistake the last connection (to the upp caused, connect the cable to a s possible. (Avoid the work equipm conductor) When removing the booster cab booster cable clips may not con chassis. NOTICE The starting system for this mach ine uses 24V. For the normal machine, also use a 24V battery The size of the booster cable and clip should be suitable for the battry size. The battery of the normal machin e must be the same capacity as that of the engine to be start Check the cables and clips for da mage or corrosion. s are firmly connected.

Make sure that the cables and clip Check that the safety lock levers and parking brake levers of both machine are in the LOCK po Check that each lever is in the NE UTRAL position.