. MAINTENANCE OUTLINE OF SERVICE Fuel 4 - 5 The fuel pump is a pr ecision instrument, and if fuel containing wat er or dirt is used, it cannot work pro Be extremely careful not to let impurities get in when storing or ad Always use the fuel s pecified in the Operation and Maintenance M Fuel may congeal, de pending on the temperature, when it is used (particularly in low temperature bel ow -15°C (5°F)).
It is necessary to change to the fuel that is suitable for the To prevent the moistu re in the air from condensing and forming wat er inside the fuel tank, always fill the fuel tank after completing the d Before starting the en gine, or when 10 minutes have passed after a dding fuel, drain the sediment and w ater from the fuel tank. If the engine runs out of fuel, or if the filters have been replaced, it is necessary to bleed the air from t he circuit. If there is any foreign material in the fuel tank, wash the tank and f NOTICE e fuel.
Always use diesel oil for th To ensure good fuel consu mption characteristics and exhaust gas characteri stics, the engine mounted on this machi ne uses an electronically controlled hi gh-pressure fuel injection device. This device req uires high precision parts and lubrication , so if low viscosity fuel with low lubr icating ability is used, the durability may drop mar kedly. Cooling System Coo lant for use, so always use distilled water or tap water (soft water) when diluting the coolant. as river water or well water (hard water), contains large amounts of minerals (calcium or The coolant is diluted coolant.
Natural water, such ntains large amounts of minerals (c alcium or magnesium) and will cause scale to form inside the engine and th e radiator. Once scale forms, it is difficult to remove, and it will ca use deficient heat exchange, leading to over heating. To prevent this, we recom mend the use of water with a m aximum overall hardness of 100 ppm (mg/ l ) when diluting the coolant. he Operation and Maintenance Manual. When using antifreez e, always observe the precautions given in t he Operation and Maintenance Man Komatsu machines a re supplied with Komatsu original anti-freeze in the coolant when the machine is shipped.
This anti-freeze is eff ective in preventing corrosion of the cooling s ystem. The anti-freeze can b e used continuously for two years or 4000 ho urs. Therefore, it can be used as it i s even in hot areas. ble, so be extremely careful not to expose it to flame or fire. i-freeze to water differs according to the ambient temperature. ing proportions, see "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-22)". ts, wait for the engine to cool before adding coolant.
Antifreeze is flamma ble, so be extremely careful not to expose it t The proportion of ant i-freeze to water differs according to the amb For details of the mix ing proportions, see "CLEAN INSIDE OF CO If the engine overhea ts, wait for the engine to cool before adding c If the coolant level is l ow, it will cause overheating, and will also cau se problems with corrosion due to ai r entering the coolant.