Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 6 the 3) Replace both inner (1) lights up soon after 5) When replacing the the same box as the element. Stick the seal in the position shown in the diagram on the right. 6. Remove the cloth or tape cover installed in Step 3. 7. If small holes or thinner parts are found on the element when it is checked by shining a light through it after cleaning, replace the element. NOTICE Do not clean and reinstall a inner element. 4 - 21 5. Direct dry compressed air (less than 0.69 MPa (7 kg/cm2, 9 nt from inside along its folds, th PSI)) to the outer eleme direct it from outside along 1) Remove one seal from has been cleaned.

2) Replace the outer el times repeatedly or us inner element at the s its folds and again from inside. nd outer elements when the air cleaner c logging monitor outer element even though it has not been cleaned 6 time play in the inner element. If any pla y is fo und, push it in p ement, stick on seal (A) packed When cleaning the element, do Do not use an element whose f olds or gasket or seal are damaged. Replacing Inner Element 1. First remove the outer ele ment, and then remove the inner element. 2. Cover the air connector si de (outlet side) with a clean cloth or tape. 3. Clean the air cleaner body interior, then remove the cover installed i 4.

Fit a new inner element to the connector and tighten it with nu 5. Install the outer element a 6. After replacing the eleme will return to its original position.