Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE minutes at low idle, then for 5 minutes at high idle. and add water if the level is low. 4 - 24 3. Remove the under cover ( 4), then set a container to catch the coolant under drain valves (5) and (6). Open drain valve ( 5) at the bottom of the radiator to drain the water. Open drain v alve (6) at the cylinder block to 4. After draining the water, tig hten drain valves (5) and (6), an d fill with tap water. When the radiator is full, start the engine and run at low idling. Keep th e engine running at low idling fo r 10 minutes until the water te (194°F). Stop the engine, open dra water. 0°C 6.

After draining the water, c lean the radiator with detergent For the cleaning method, Close drain valves (5) and Replace the corrosion res For details of the method cartridge, see "REPL CARTRIDGE (PAGE 4-71 9. Install undercovers (4). 10. Add water through the wa 11. To remove air in the cooli (While doing this, leave th 12. After draining off the cool lean the inside of the reserve ta nk and refill the water between F ULL and LOW level. 13. Stop the engine and tighte n the cap. Check the coolant l evel,