. MAINTENANCE MAINTENANCE PROCEDURE METHOD FOR RELEASING INTERNAL PRESSURE IN HYDRAULIC CIRCUIT RELEASING PRESSURE FROM WORK EQUIPMENT CIRCUIT, SWING CIRCUIT, TRAVEL CIRCUIT WARNING 4 - 40 The hydraulic s ystem is always under internal pressure, so when inspecting or replacing the pipin g or hoses, always release the pressure in t he circuit before starting. If th e pressure is not r eleased, high pressure oil may sp urt out and cause serious personal injury. The parts and oi l are at high temperature after the engine is stopp ed, and may cause serious burn s. Wait for the temperature to go down befo re starting the operation.
When the oil fill er cap is removed, oil may spu rt out, so turn the c ap slowly to release the pressur e before removing the cap. 1. Stop the ma chine on firm horizontal gr ound, lower the work equipment to then stop the Set the loc the ground as shown in th e diagram on the right, engine. k lever at the FREE position. h work equipment control lever to the full stroke econds after stopping the engine. starting switch at the ON position. cap of the hydraulic tank. ine, run for approx. 10 seconds, then stop the . the engine at more than 1000 rpm. k lever at the FREE positio 2.
Operate eac within 5 - 6 s h work equipment control l econds after stopping the e Leave the starting switch at the ON p 3. Remove the cap of the hydraulic tank. 4. Start the eng engine again Do not run Set the wo the engine at more than 1 rk equipment control levers to the HOLD position. 5. Operate eac h work equipment control l ever to the full stroke ngine. roke within 5 - 6 s Repeat St econds after stopping the e eps 4 - 5 three times. RELEASING PRESSURE IN ACCUMULATOR CIRCUIT After stopping th e engine, set lock lever (1) to the FREE position, then operate eac h work equipment control l ever 3 - 4 times t o the end of the strok relieved. e.
After 1 minute, the internal pressure will be Do not loosen any piping until at least 1 m inute has passed after relieving the in ternal pressure.