Komatsu — EVERY 250 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CHECK ALTERNATOR DRIVE BELT TENSION, ADJUST Checking 4 - 51 The standard de flection for the drive bel t is 15 mm (0.59 i n) when pressed with a t humb [at approx. 58.8 N (approx. 6 kg)] at a point midway betwee n the drive pulley and alt Adjustment 1. Insert a bar hold alternat When holdin and alternat 2. Loosen the alternator (6 Adjust the TIGHTEN LOOSEN 3. After adjusti (5) to (1) (th nut (5). Check ea wear of th not conta If the V-be adjustme When the running fo between alternator (6) and the cylinder block to or (6) in position. 1.

hold alternat When holdin g in position, put a wood en block between the bar and alternat or (6) to prevent damag e to alternator (6). 2. Loosen the alternator (6 Adjust the belt tension with nut (5 to INCREASE tension to DECREASE tension 3. After adjusti ng the belt, tighten the b olts and nuts in th e order (5) to (1) (th e opposite order from lo osening). Finally, tighten nut (5). Check ea ch pulley for damage, wear of the V-groove, and e V-belt. Check in parti cular that the V-belt does oove. ct the bottom of the V-gr If the V-be lt is elongated and ther e is no more allow ance for nt, or if the belt is cracke d or cut, replace t he belt.

When the V-belt has been replaced, adjust again after r 1 hour.