Komatsu — OPERATION

. ATTACHMENTS AND OPTIONS AUTO-GREASING SYSTEM METHOD OF ADJUSTING INJECTOR DISCHARGE AMOUNT CAUTION of pin is (0.7 turn fully the 3. After adjusting the discharge from the injector, be sure to tighten lock nut (2). 6 - 17 The setting of the injector disch arge amount differs according to t he type of machine and the type of w ork. For this reason, i t is necessary for the customer him self to set the injector discharge a mount to match the working conditi on of the machine . The injector is operated b y the pressure from the pump, f eeds grease of the specif ied quantity to the bearing. To ks normally, check the opera i r r d. If the injector is normal, the etracted first.

If the pump stops and the pressure is lost, eturns and it is reset for t he next greasing. Although the injector can b e overhauled and repaired, rep with a spare one, if possib le, when it has any trouble. Th e in jector discharge amo unt is set to the center positio cc/ST) when the machine is shipped from the factory. Adjustment procedure Adjust the discharge from the injector with adjustment screw its hard. 1. To reduce the dischar ge, loosen lock nut (2) an adjustment screw (3) clo (at the stopper), the disc ckwise. If the adjustment screw harge is minimized. 2.

If t he adjustment screw is returned by 10 turns from th tightened position (mini discharge is maximized ( mum discharge) in 1] abov 1.3 cc/ST). Tightening torque for lock nut (2): 19.6 to 24.5 Nm (2.0 to 2.5 kgm , 14.5 to Discharge/time Turn clockwise to stopper 0.13 cc (Min) Turn counterclockwise by 1 from above position 0 turns 1.30 cc (Max)