. LOADING SHOVEL MAINTENANCE MAINTENANCE CHECK BEFORE STARTING Check Oil Level in Hydraulic Tank, Add Oil WARNING diagram on the right. 4. If the level is below the correct line, add oil through filler port (F) at the top of the hydraulic tank. NOTICE Do not add oil above the correct level. This may damage the hydraulic circuit and cause the oil to spurt out. as follows. 7 - 23 If the oil filler cap is removed without releasing the internal pressur e, oil will spurt o ut, so turn the oil filler c ap slowly to release the internal pressure, then re move it carefully. 1.
If work equipment is n ot in the condition shown in diagr am on the right, start engine bucket cylinders, then contact with the groun , run at low idle, retract the ar m and lower the boom, set bucket teeth in d, and stop the engine. fter stopping the engine, turn starting 2. Within 15 seconds a arting switch to the ON positi equipment, travel) in pressure. on, and operate the control levers (work each direction to release the internal ternal 3. Check oil level gauge (G) at the rear of the hydraulic ta nk on the right side of the ma specified range for tha add oil. chine. The oil level should be with in the t oil temperature.
If the oil level is low, The proper way to check t he hydraulic oil level is as follows . to 30° When the hydraulic oil is at normal temperature (15°C C), the oil level should b in the diagram on the ri e within the blue range of gauge la bel (a) ght. When the hydraulic oil i s at high temperature (50°C to 80° C), the n the red range of gauge label (b) in the 5. If oil is added to above the correct line, and drain the exc ess oil