Komatsu — SWITCHES

. OPERATION DETAILED CONTROLS AND GAUGES Lamp Switch lamps, reset stops Machine Push-up Switch WARNING 3 - 31 orking additional lamp s at top front o f the ca b, and m onito r lighting. Alarm Buzzer St op Switch is used (when the engine is running) to stop the This switch (6) is used (whe he alarm hen it has sounded to warn of a problem in a ounded REMARK This switch is a This pressed, the al arm buzzer returns to its ori ginal position. pe.

If th e STOP position is nd the switch automatically When using the b oom thrust forc e to push up the ch assis whe n moving down from a bench, ther e is danger that the machi ne may suddenly go dow n and turn over , so set to the high-pressure This switch (7) i s used to switc h the sa fety valv e set pressure at t he head end of the boom cylinde r to two levels. (a) Low pressur e setting: hrust force is weak, so swaying of the chassis is The boom t the chassis small during digging operations, a nd diggi ng ca n be performed smoothly. This is used for general d igging o peration s on normal ground, soft rock, or blasted rock.

(b) High pressu The boom th rust force becomes m ore powerful, so i t is easy to twist and sw ing or escape from s igging operations usi e from s oft ground. It effective performing d ucke the machine in confined a reas.