Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-98 Align the swivel bracket (2) with the injector hold down capscrew hole. Install capscrew, Part No. 3823600, through the swivel bracket. The capscrew is included in the timing tool kit. NOTE: If the capscrew (3) is tightened too tight, it will restrict the piston rod travel. Tighten the capscrew (3) enough to hold the timing fixture rigid. Position the timing tool push rod plunger bracket (4) on the back side of the center bracket (5). Use the alignment tool (6) to align the push rod plunger rod (7). Tighten the clamp handle (8) after the plunger rod is aligned, and remove the alignment tool.