Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-103 Install the assembled camshaft gear puller on to the cam- shaft gear. Insert the adapter (1) of the non-slotted hole in the puller plate (2) onto the camshaft gear first. The adapter pulling surfaces (3) must point toward the center of the camshaft gear. Slide the capscrew and adapter of the slotted end of the puller plate (4) toward the end of the puller plate and insert the adapter onto the camshaft gear. The adapter pulling surface (3) must point toward the center of the camshaft gear. While holding the puller in place with one hand, tighten the capscrew on the end of the puller plate (5).
Make certain the puller adapters are hooked completely over the camshaft gear. Torque the capscrew (5). Torque Value: 7 [60 in-lb] Use graphite to lubricate the pressure screw of the puller. Turn the pressure screw clockwise to remove the gear. If the camshaft key is marked with an arrow, record the direction of the arrow. Remove the camshaft gear key. The accompanying table lists offset keys by part number and degree of offset. Never advance static injection timing beyond the speci- fication limits. The engine durability will be affected.