Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-106 Use a new gasket and install the camshaft rear cover plate. Tighten the three capscrews (M10-1.50 x 22). Torque Value: 47 [35 ft-lb] Use a dial indicator gauge assembly, Part No. 3376050, with an extension, Part No. ST-537-4, and a magnetic base, Part No. 3377399, to measure the camshaft end clearance. Place the contact tip of the gauge against the face of the gear. Camshaft End Clearance mm in 0.13 MIN 0.005 0.33 MAX 0.013 Install the camshaft idler gear. Refer to ‘‘Idler Gear As- semblies - Installation’’ earlier in this procedure.
Gear Cover - Installation Insert a new seal into the groove on the front of the gear housing. Apply silicone sealant, Part No. 3823494, to the overlap joint. Install a new seal ring at the accessory drive (1) and water pump (2) locations. Install six new capscrew o-rings at the crankshaft seal capscrew locations (3).