Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-111 Accessory Drive Pulley - Installation NOTE: Accessory drive seal dust seals are currently only to be installed on single v-groove stamped steel accessory drive pulleys. The dust seal is not compatible with other pulleys. Place a light film of oil or anti-freeze on the inside diam- eter of the accessory drive oil seal dust seal. Install the dust seal onto the accessory drive pulley hub so that the larger outside diameter of the dust seal is facing away from the pulley. Push the dust seal onto the hub until the inside diameter of the dust seal is flush with the pulley hub end. Caution:
To prevent dowel pin damage, the slot (1) in the pulley must align with the dowel pin (2) in the shaft. The timing marks on the pulley must be facing away from the engine. This is a slip fit pulley. It does not require the use of an installation tool. Install the pulley on the accessory drive shaft by hand. Install the pulley retaining capscrew (M20-2.50 X 50). Torque Value: 542 [400 ft-lb] Rocker Lever Housing - Installation The rocker lever housing must be installed before the injectors on M11 engines. Use a new gasket and install the rocker lever housing using four mounting capscrews (M10-1.50 x 100) and 20 mounting capscrews (M10-1.50 x 35).