Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-122 Use five wire clamps and capscrews (M8-1.25 x 20) to install the inside section of the actuator harness to the inside of the rocker housing. The harness and the con- nectors must be clear of any moving parts, so the wires will not be damaged during engine operation. Torque Value: 20 [15 ft-lb] Lubricate the connector ends with lubricant DS-ES, Part No. 3822934. Connect the Deutsch two pin connectors from the internal actuator harness to the same injector as they were re- moved from. Install the harness wire bracket to the cylinder block at points (1) and (2). Use two capscrews (M10-1.50 x 20).
Torque Value: 41 [30 ft-lb] Install the external actuator harness on the engine. Install the harness holding clamps to the support bracket and to the rear of the engine block. Tighten the capscrew. Torque Value: 20 [15 ft-lb]