Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-133 Engine - Removal From The Rebuild Stand Use four capscrews (M10-1.50 x 40) and temporarily in- stall the front lifting bracket to the rocker lever housing. Use two capscrews (M12-1.75) and fasten the rear lifting bracket to the cylinder head. Torque Value: 70 [55 ft-lb] Warning: To prevent personal injury, use a properly rated hoist to lift the engine. The engine weighs approximately 940 kg [2070 lb]. Use lifting fixture, Part No. 3822512, and a hoist with a minimum lifting capacity of 1.8 M ton [2.0 tons] to lift the engine. Warning:
The engine can move or drop a small distance as it is being removed from the rebuild stand. Use ex- treme care to prevent personal injury. Use the hoist and lifting fixture to apply lifting tension to the engine. Remove the ten capscrews that hold the engine to the adapter plate. Lower the engine to the engine support stands, Part No. 3376057, or a shipping skid with the hoist. Remove the hoist and lifting fixture from the engine. Remove the front lifting bracket.