Section 0 - Engine Disassembly and Assembly - Group 00 Engine Assembly (0-02) M11 Page 0-135 Thermostat Housing Support - Installation Use a new gasket and install the support with four capscrews (M10-1.50 x 35). NOTE: The capscrews are not tightened to their final torque value at this time. Torque Value: 20 [15 ft-lb] Install the air compressor water outlet tube to the fitting on the thermostat housing support. Torque Value: 20 [15 ft-lb] Install the sensor harness coolant temperature sensor connector to the coolant temperature sensor. Tighten the water header plate capscrews in the sequence shown. Torque Value:
55 [40 ft-lb] Water Pump - Installation Install a new o-ring on the water pump mounting flange. NOTE: The water pump must be twisted outward from the top until the transfer outlet clears the thermostat housing support during installation. Install the water pump. Install a new o-ring on the water pump water transfer tube. Install the connection into the water pump. Twist the water pump inward and install the three water pump mounting capscrews. Torque Value: 47 [35 ft-lb] Install a new gasket on the water pump water transfer connection. Install and tighten the water transfer con- nection capscrews. Torque Value: 25 [18 ft-lb]