Cam Follower Assembly - Rebuild (4-02) Section 4 - Cam Follower Assembly - Group 04 M11 Page 4-8 Cam Follower Assembly - Rebuild (4-02) The cam follower assembly consists of two shaft assem- blies, (1) and (2), installed on the engine with a common center support (3). Disassembly The cam follower levers have established wear patterns and must be installed in the same position they were removed from. Mark the end supports and all of the cam followers to identify their position, front and rear, when they are removed. The end supports are not interchangeable. Remove the end supports (1) from the shafts.
Remove the valve cam followers (2), injector cam follow- ers (3), valve cam followers (4), and shaft supports (5). Install the cam follower shafts in a vise with brass jaws. Center punch the plugs in the ends of the shafts.