Fuel Pump - Rebuild (5-02) Section 5 - Fuel System - Group 05 M11 Page 5-12 Fuel Shutoff Valve - Cleaning and Inspection Clean all of the parts except the coil assembly in mineral spirits. NOTE: Do not get the coil wet with solvent. Clean the coil with a dry cloth. Polish the coil face with a 200 grit emery cloth on a flat surface. Visually check the valve disc, valve seat, and actuator disc for dirt, metal parts, bonding separation, corrosion, cracks or wear. Replace if necessary. Check the coil assembly with an ohm meter. Replace the coil if it is not between 7 and 8 ohms resistance. NOTE: If the coil assembly shows zero ohms, there is elec- trical short in the coil.
Fuel Shutoff Valve - Assembly Assemble the shutoff valve as shown. Install these parts as follows: Place the pump support side down. Install a new o-ring (6). Install the actuator disc (5) with cup side toward the coil. Install the valve disc (4) with raised area up. Install the spring washer (3) with cup side toward the coil. Install the spacer (7) o-ring groove toward the coil. Install the fuel shield (2) and coil (1) on the front cover (8). Hold the assembly together, insert the capscrews and tighten. Torque Value: 3 [30 in-lb]