Intake Manifold - Cleaning and Inspection for Reuse (10-02) Section 10 - Air Intake System M11 Page 10-6 With the feeler gauge in the same location, push the compressor wheel by hand away from the compressor housing. Install a wire feeler gauge, at the same point. Record this clearance. Subtract the smaller from the larger clearance. Compressor Wheel Radial Clearance mm in 0.15 MIN 0.006 0.64 MAX 0.025 If the radial clearance does not meet the above specifi- cations, the turbocharger must be rebuilt. Refer to Turbo- charger Component Shop Manual, Bulletin No. 3379461, for rebuild instructions.
Intake Manifold - Cleaning and Inspec- tion for Reuse (10-02) Cleaning Remove the air inlet housing. Remove all gasket material. Warning: When using a steam cleaner, wear protective clothing and safety glasses or a face shield. Hot steam will cause serious personal injury. Use solvent or steam to clean the parts. Dry with com- pressed air. Inspection Visually inspect the intake manifold and inlet housing for cracks or damage. Replace damaged parts.