Alternator Bracket - Cleaning and Inspection for Reuse (13-04) Section 13 - Electrical Equipment - Group 13 M11 Page 13-4 Inspection Visually inspect the gear (1) for cracked or broken teeth. Visually inspect the drive bushing (2) and the gear shaft (3) for excessive wear or damage. Visually inspect the terminal posts (4) for loose or broken connections. If the starting motor parts are damaged or the posts are loose or damaged, the starting motor must be repaired or rebuilt. Refer to the electrical equipment manufacturers specifications to rebuild the starting motor.
Alternator Bracket (Bus Applications) - Cleaning and Inspection for Reuse (13-04) Cleaning Use solvent to clean the upper and lower alternator brack- ets. Dry with compressed air. Inspection Inspect the upper bracket for cracks. If the bracket is cracked, it must be replaced. Inspect the pivot bushing for cracks and a tight fit in the upper bracket. If the bushing is cracked, but the bracket appears un- damaged, replace the bushing with bushing, Part No. 3883412. If the bracket is damaged and the old bushing no longer fits securely, replace the bracket and the bushing.