Engine Dynamometer - Install Engine (14-01) Section 14 - Engine Testing - Group 14 M11 Page 14-30 Connect the dynamometer test OEM wiring harness pin connector to the actuator harness power connector (shroud). To save, adjust, and write parameters to and from the ECM, refer to the CELECT™Compulink™Cartridge Manual, Bulletin No. 3810472. NOTE: Parameters must be returned to their original value when the test or run-in is completed. Connect the dynamometer test OEM wiring harness 9 pin connector to the sensor harness 9 pin connector. Connect battery power to the starter. Connect the dynamometer test OEM wiring harness starter solenoid lead (yellow) to the starter solenoid.
Con- nect the ground lead (black) to the starter or battery nega- tive or ground side. Connect the positive 12 VDC power lead (red) to either the starter or battery positive (+12 VDC) side.