Section 0 - Engine Disassembly and Assembly - Group 00 Engine Disassembly (0-01) M11 Page 0-27 Caution: Do not allow the hydraulic drive gear to slide out of the adapter or the gear housing during removal. Damage to the gear will result. Remove the hydraulic drive adapter, o-ring, and hydraulic drive gear. Sensor Harness and Sensors - Removal Tag all connections as they are removed for future iden- tification. Disconnect the connector (1) that connects the sensor and actuator harnesses. Remove the sensor harness connectors from the follow- ing sensors:
engine position sensor (2) (back of gear housing), oil temperature sensor (3) (fuel pump side of block), oil pressure sensor (4) (fuel pump side of block). Remove all the sensor wiring harness clamps from the engine and the sensor wiring harness. Remove the harness bracket from the cylinder block. Remove the oil temperature sensor (1) and oil pressure sensor (2) from the cylinder block. Remove the engine position sensor (3) from the rear of the gear housing. Rocker Lever Cover - Removal Remove the breather tube and the tube retaining clip (1) from the side of the cylinder block. Remove the 16 capscrews, isolators and spacers from the cover. Remove the cover and gasket.