Rear Engine Power Takeoff (REPTO) - Rebuilding (16-05) Section 16 - Mounting Adaptations - Group 16 M11 Page 16-12 Assembly Install a new o-ring on the idler shaft bushing. Use Lubriplate to lubricate the o-ring. Support the housing evenly with the engine mating sur- face up. Press the new bushing into the housing until it is below the surface of the cylinder block mating surface. Use Lubriplate W 105 to lubricate the larger bearing race. Use the larger end of driver, Part No. 3823893, to press the bearing race to the shoulder in the housing. Turn the housing over and support it evenly in the press. Use Lubriplate™105 to lubricate the smaller bearing race.
Use the smaller end of driver, Part No. 3823893, to press the bearing race to the shoulder in the housing.