Rear Engine Power Takeoff (REPTO) - Rebuilding (16-05) Section 16 - Mounting Adaptations - Group 16 M11 Page 16-14 Temporarily install the output flange before installing the oil seal. Use clean 15W-40 oil to lubricate the splines. Install the flat washer and capscrew. Use gear locking tool, Part No. 3823891, to hold the output shaft while tightening the capscrew. Torque Value: 205 [150 ft-lb] Measure the shaft end play. REPTO Shaft End Play mm in 0.00 MIN 0.000 0.03 MAX 0.001 Check the output shaft rolling resistance with a torque wrench. The rolling resistance must be between 0.6 to 1.1 [5 to 10 in-lb].