Section 0 - Engine Disassembly and Assembly - Group 00 Engine Disassembly (0-01) M11 Page 0-29 Internal Actuator Harness - Removal Use a Torx screwdriver (T25) to loosen the screw which secures the two sections of the actuator harness together at the rear of the rocker lever housing. The screw head is accessible from inside the rocker lever housing. Disconnect the two sections of the actuator harness. Disconnect the ground wire connection of the actuator harness (1) from the engine. Tag the end for future identification. Remove the external section of the actuator harness. Use care not to damage the plug as it is being removed from the rocker housing.
Disconnect the wire connectors from the injectors. Tag the connectors for future identification. The connec- tors must be connected to the same injector as they were removed from when the engine is reassembled. Remove the five capscrews and wire clamps which hold the harness section to the rocker housing.