Section V - Specifications - Group 18 Component Specifications and Torque Values M11 Page V-19 Component or Assembly (Procedure) Ref.No./Steps Metric U.S. Cylinder Block Liner Seal Seat Bore I.D. 138.063 mm MIN 5.4355 in 138.113 mm MAX 5.4375 in Main Bearing Bore I.D. 121.990 mm MIN 4.8028 in 122.015 mm MAX 4.8037 in Cylinder Block Thrust Bearing Surface Width 39.95 mm MIN 1.573 in 40.05 mm MAX 1.577 in Main Oil Pressure Regulator Valve Bore 22.226 mm MIN 0.8750 in I.D. 22.301 mm MAX 0.8780 in High Oil Pressure Relief Valve Seat Depth 62.62 mm MIN 2.465 in 63.62 mm MAX 2.505 in Idler Gear Ring Dowel Bore I.D. 19.175 mm MIN 0.7549 in 19.215 mm MAX 0.7565 in Camshaft Bushing I.D.
(Installed) 72.078 mm MIN 2.8377 in 72.142 mm MAX 2.8402 in Note: If one of the bushings exceeds the specifications, all of the bushings must be replaced.