Section V - Specifications - Group 18 Cylinder Block - Rebuild M11 Page V-29 Component or Assembly (Procedure) Ref.No./Steps Metric U.S. Valve Insert Bore I.D. (Standard Insert) 45.920 mm MIN 1.8073 in 45.935 mm MAX 1.8085 in Note: Refer to Cylinder Head - Oversize Valve Seat Installation (2-05) for oversize valve insert dimensions. Injector Tip Protrusion: (Used Injector Sleeve) 2.28 mm MIN 0.090 in 2.65 mm MAX 0.104 in (New Injector Sleeve) 2.28 mm MIN 0.090 in 2.54 mm MAX 0.100 in Crosshead Stem Pocket to Pad Face 12.05 mm MIN 0.474 in 12.55 mm MAX 0.494 in Cylinder Head - Torque Values Cylinder Head Pipe Plugs 10 8 ft-lb Note:
The pipe plugs (1) located in the front of the cylinder head must be installed below the surface of the cylinder head. Rocker Lever Assembly - Rebuild Specifications Rocker Lever Bushing Bore I.D. 34.887 mm MIN 1.3735 in 34.990 mm MAX 1.3776 in Rocker Lever Bore I.D. 36.474 mm MIN 1.4359 in 36.499 mm MAX 1.4370 in Rocker Lever Shaft O.D. 34.837 mm MIN 1.3715 in 34.864 mm MAX 1.3726 in