Section V - Specifications - Group 18 Cylinder Block - Rebuild M11 Page V-39 Component or Assembly (Procedure) Ref.No./Steps Metric U.S. Hydraulic Pump Drive Shaft Installed Height in the Drive 18.50 mm MIN 0.728 in Gear 19.50 mm MAX 0.768 in Hydraulic Pump Drive Rear Adapter Bore Bearing Depth 0.254 mm MIN 0.0100 in 0.762 mm MAX 0.0300 in Air Intake System - Inspection Specifications Turbocharger Shaft Axial Movement 0.038 mm MIN 0.0015 in 0.089 mm MAX 0.0035 in Compressor Wheel Radial Clearance 0.15 mm MIN 0.006 in 0.64 mm MAX 0.025 in Note: Specifications and instructions for rebuilding the turbocharger are provided in the Turbocharger Component Shop Manual, Bulletin No. 3379461.
Exhaust System - Torque Values Exhaust Manifold Flange To Turbocharger Mounting Stud Torque 65 50 ft-lb Note: Apply a coat of anti-seize compound to the threads. Use two mounting nuts locked together to tighten the studs. Single Cylinder Air Compressor 0.05 mm MIN 0.002 in Crankshaft End Clearance 0.15 mm MAX 0.006 in Note: Specifications and instructions for rebuilding the single cylinder air compressor are provided in the Air Equipment Rebuild Manual, Bulletin No. 3810457. Air Equipment - Inspection Specifications Two Cylinder Air Compressor Crankshaft End Clearance 0.05 mm MIN 0.002 in 0.19 mm MAX 0.008 in Note:
Specifications and instructions for rebuilding the two cylinder air compressor are provided in the Air Equipment Rebuild Manual, Bulletin No. 3810347.