Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-52 Put the installation tool bridge (1) across the liner and install the two cylinder head capscrews finger tight to hold the bridge down. Rotate the force plate until the areas where the protrusion measurements will be taken are exposed. Caution: Do not use an impact wrench to tighten the liner force plate screw. Excessive torque will cause dam- age to the liner installation tool. Tighten the forcing screw (2). Torque Value: 136 [100 ft-lb] Check for correct protrusion. Use a depth gauge, Part No. 3823495, to measure the liner protrusion at four points 90 degrees apart.
Cylinder Liner Protrusion mm in 0.00 MIN 0.000 0.13 MAX 0.005 If the protrusion varies more than 0.025 mm [0.0010 inch]: Remove the liner.