Engine Assembly (0-02) Section 0 - Engine Disassembly and Assembly - Group 00 M11 Page 0-66 Remove the four alignment plate capscrews and the align- ment plate. Flywheel Housing Bore Alignment - Measure- ment NOTE: On REPTO flywheel housings, dial gauge attach- ment, Part No. ST-1325, must be spaced out from the fly- wheel and longer mounting capscrews used. An alternative method is to use a magnetic base with the dial indicator gauge. Use dial indicator gauge, Part No. 3376050, (1) and dial gauge attachment, Part No. ST-1325, (2) to measure the bore alignment. Install the attachment and gauge as shown. Install the engine barring tool, Part No. 3824270, to rotate the crankshaft.
Position the indicator at the 12 o’clock position. Adjust the gauge dial to (zero). Rotate the crankshaft one complete revolution (360 de- grees) and record the TIR. Flywheel Housing Bore Alignment Maximum TIR mm SAE No. in 0.31 00 0.012 0.25 0 0.010 0.25 1/2 0.010 0.20 1 0.008 0.20 2 0.008 0.20 3 0.008 If the maximum bore alignment does not meet the speci- fications, use a mallet to move the housing in the nec- essary direction.