hitachi — CAN HARNESS CHECK

TROUBLESHOOTING / Troubleshooting A · Key switch: OFF ICF Connector ICF-C (Harness end) #C5 T1V1-05-04-002 #C11 ECM Connector (Harness end) #18 #37 T1GR-05-04-002 T183-05-04-013 T5-6-56 YES Short-circuited CAN harness. NO Check the Connect connector connection of MC YES in MC. and connector. A Check if fault code Connect all 11004-2 is connectors except displayed. Faulty MC. connector MC-C in YES MC. · Key switch: ON Check if resistance Check the between terminals NO Connect connector connection of ICF #C4 and #C15 of NO harness end of Connect connector in YES i Cn h I eC cF k. if fault code and connector. connector MC-C is MC. Disconnect 11004-2 is within 60±10 Ω.

connector ICF-C in displayed. Faulty ICF. ICF. YES · Key switch: OFF Check if resistance · Key switch: ON between terminals #C5 and #C11 of Connect connector NO harness end of Connect connector in YES in ECM. Check if connector is within ICF. fault code 11004-2 60±10 Ω. Disconnect is displayed. connector in ECM. · Key switch: OFF Check if resistance · Key switch: ON between terminals NO #18 and #37 of Connector Connect connector in harness end of ECM. connector is within Disconnect MC 120±10 Ω. Connector MC-C connector monitor-B (Harness end) · Key switch: OFF NO in monitor unit. #C4 #C15 Check if resistance between terminals C1 C10 #B6 and #B7 of harness end of connector is within 120±10 Ω.

C23 C31 Connect connector in ECM. Check if YES fault code 11004-2 is displayed. · Key switch: ON Connect connector in ECM. Disconnect connector monitor-B fault code 11004-2 is displayed. Connect connector in ECM. Disconnect connector monitor-B NO in monitor unit. Check if resistance between terminals #B6 and #B7 of harness end of connector is within 120±10 Ω. YES Short-circuited CAN harness. Connect connector in MC. Check if fault code YES 11004-2 is displayed. Connect all connectors except connector MC-C in MC. Check if resistance between terminals #C4 and #C15 of NO harness end of connector MC-C is within 60±10 Ω. Connect connector in ICF. Check if fault code YES 11004-2 is displayed.

Connect connector in ICF. Disconnect connector in ECM. Check if resistance between terminals NO #18 and #37 of harness end of connector is within 120±10 Ω. # onitor Unit onnector Monitor-B Connector Harness end) #B6 #B7 #B6