TROUBLESHOOTING / Troubleshooting B RELATIONSHIP BETWEEN MACHINE TROUBLE SYMPTOMS AND RELATED PARTS This table indicates the relationship between machine trouble symptoms and the potential problem parts, which may cause trouble if failed, and the evaluation methods of these components. T5-7-2 Item Parts Function Symptoms in control system when trouble occurs. Symptoms in machine operation when trouble occurs. Engine Control Dial • Instructs engine target speed. • Engine speed is kept at idling speed when trouble occurs with key ON. • Engine speed is kept at speed just before trouble occurred when trouble oc- curs during operation.
• Engine speed is kept at idling speed when trouble occurs with key ON. • Engine speed is kept at speed just before trouble oc- curred when trouble occurs during operation. Pump Control Pressure Sensor • Monitors pump control pres- sure in order to control travel motor swash angle control. • E mode control In normal, P speed is re- turned whenever operating. P speed is not returned when this trouble opccurs. • Heater Control Heater control is ineffective. • Travel motor displacement angle control The machine travels at slow speed. • E mode control In normal, P speed is re- turned whenever operating. P speed is not returned when this trouble opccurs.
• As the machine is kept to travel at slow speed, speed does not change into fast automatically. Pump 1 Delivery Pres- sure Sensor • Monitors pump delivery pressure in order to control HP mode, slow speed torque increase, auto-power lift and travel motor swash angle controls. • HP mode control Engine speed does not in- crease. • Travel HP mode control This control is operated by pressure except P1. • P-Q torque correction Torque does not increase. • Travel torque-up control The machine may mistrack. • Bom regeneration control Arm regeneration control is ineffective. • Digging regeneration control Digging regeneration control is ineffective. • Auto-power lift control.
Auto-power lift control is in- effective. • Travel motor displacement angle control. The machine travels at slow speed. • During combined operation of boom raise and arm roll-in or of arm roll-in and swing, arm speed is slow. • During boom raise operation, lifting power is weak. • As the machine is kept to travel at slow speed, speed does not change into fast.