TROUBLESHOOTING / Troubleshooting B A-7 Actuator speed is faster than normal Machine mistracks when travel lever is op- erated at half stroke. Precise control cannot be performed. Related MC Fault Code: None The pump 1 or 2 flow rate is maximized due to some reasons. Therefore, the maximum flow rate is supplied and actuator speed is faster though the control lever does not reach the full stroke. Pressure oil from pump 1 makes right travel per- form, and pressure oil from pump 2 makes left travel during single travel operation. When the travel lever is operated at half stroke, different flow rates between pump 1 and 2 occur and the machine mistracks.
Refer to the SYSTEM / Hydraulic System group in the T/M (Operational Principle). YES Faulty pump regulator. Monitor pump control pressure of pump 1 and 2. Check if pressure changes in response to lever operation. · Pump 1: Bucket operation · Pump 2: Swing operation · Monitor item: Pump 1 and 2 pump control pressures · Possible to display by service menu and monitoring in monitor unit. Bound pump flow rate control valve in signal control valve. NO T5-7-96