TROUBLESHOOTING / Troubleshooting B T5-7-163 Position to be checked Remedy Communication line between MC and ICF (CAN bus line) • Check for continuity between terminals #C5 of connector ICF-C in ICF and terminals #B7 of connector monitor-B in monitor unit. (Re- fer to T5-7-161.) • Check for continuity between terminals #C11 of connector ICF-C in ICF and terminals #B6 of connector monitor-B in monitor unit. (Re- fer to T5-7-161.) • Check for shorted circuit in harness between CAN circuit in ground circuit. (Refer to T5-6-62.) • Check for shorted circuit in harness between CAN circuit in power circuit.
(Refer to T5-6-65.) • Check for shorted circuit in harness between CAN circuit in key signal circuit. (Refer to T5-6-68.) • Check for shorted circuit in CAN harness. (Refer to T5-6-70.) Communication line between MC and ICF (CAN bus line) • Check for continuity between terminals #C5 of connector ICF-C in ICF and terminals #C4 of connector MC-C in MC. (Refer to T5-6-57.) • Check for continuity between terminals #C11 of connector ICF-C in ICF and terminals #C15 of connector MC-C in MC. (Refer to T5-6-57.) • Check for shorted circuit in harness between CAN circuit in ground circuit. (Refer to T5-6-62.) • Check for shorted circuit in harness between CAN circuit in power circuit.
(Refer to T5-6-65.) • Check for shorted circuit in harness between CAN circuit in key signal circuit. (Refer to T5-6-68.) • Check for shorted circuit in CAN harness. (Refer to T5-6-70.) Communication line between monitor unit and ICF (CAN bus line) • Check for continuity between terminals #C5 of connector ICF-C in ICF and terminals #18 of connector in ECM. (Refer to T5-7-160.) • Check for continuity between terminals #C11 of connector ICF-C in ICF and terminals #37 of connector in ECM. (Refer to T5-7-160.) • Check for shorted circuit in harness between CAN circuit in ground circuit. (Refer to T5-6-62.) • Check for shorted circuit in harness between CAN circuit in power circuit.
(Refer to T5-6-65.) • Check for shorted circuit in harness between CAN circuit in key signal circuit. (Refer to T5-6-68.) • Check for shorted circuit in CAN harness. (Refer to T5-6-70.)