Cooling System/Water Pump (standard model) CTM3274 (01JUL99) 30-13 Saran Liter Engines 060799 PN=212 DISASSEMBLE WATER PUMP (STANDARD MODEL) NOTE: When water pump operation is abnormal or when coolant drains from the weep hole (G), disassemble water pump as follows. 1. Remove rear cover (A) and discard gasket. 2. Using a suitable puller, remove pulley (B) or hub from bearing shaft (C). 3. Support pulley end of housing, then using a 13 mm (0.5 in.) driver, simultaneously remove impeller (D) from bearing shaft and bearing shaft from pump housing (E). Discard bearing and impeller. -UN-16JUN98 4. Using a suitable driver, remove seal (F) from pump housing and discard. 5.
Inspect water pump housing, cover and pulley for wear, debris, cracks or other damage. Replace as CD30630 necessary. NOTE: Complete or pre-assembled (H) water pumps are available for service as well as a seal kit including bearing shaft (C), impeller (D), seal (F) and gasket set. A—Rear cover B—Pulley C—Bearing shaft -UN-04MAY98 D—Impeller E—Housing F—Seal G—Weep hole H—Pre-assembled water pump CD30631 -UN-16JUN98 CD30632 Pre-assembled water pump CD,3274,G30,46 -19-04JAN99 30 13