Fuel System/Dynamic Timing CTM3274 (01JUL99) 40-56 Saran Liter Engines 060799 PN=301 11. Aim stroboscope timing light at pulley, then press the timing light push button up (A) or down (B) as necessary to align stationary pointer with reference timing marks and read the timing degree value on the display. -UN-07MAR95 -UN-05MAY95 12. Stop engine and, if necessary, rotate injection pump as follows: • If below specification, rotate pump towards engine block • If above specification, rotate pump away from CD30221 CD30198 engine block N CAUTION: Do not rotate the injection pump as long as the engine is running. This may cause the pump to seize and cause severe damage. NOTE:
1 mm (0.04 in.) offset on the injection pump flange corresponds to 2˚ on the meter display. -UN-07MAR95 13. Recheck timing until specified timing is obtained. 14. After adjustment, grind the engine front plate mark to avoid any confusion with the original timing adjustment. CD30211 NOTE: If the injection pump dynamically timed has to be removed from engine and reinstalled without any change, mark both the front plate and the injection pump flange to allow the reinstallation of injection pump at the same location. In case of repair or replacement of an injection pump dynamically timed, perform a dynamic timing adjustment. CD,3274,G40,62 -19-04JAN99 40 56