Fuel System/Fuel Injection Nozzles CTM3274 (01JUL99) 40-63 Saran Liter Engines 060799 PN=308 INSTALL FUEL INJECTION NOZZLE IMPORTANT: Each time an injection nozzle is removed from cylinder head, replace the carbon stop seal (E). -UN-17FEB95 1. Slide seal washer (F) onto nozzle body. Using JD-258 pilot tool, slide the new carbon stop seal until it fits properly into the groove. CD30323 IMPORTANT: Before installation, make sure nozzle is clean and free from oil or grease. 2. Install nozzle in cylinder head. Screw cap screw (C). Do not tighten at this stage. 3. Connect fuel injection line (D) to nozzle. Tighten pressure line to 30 N·m (23 lb-ft) using two wrenches as shown. 4.
Tighten cap screws (C) to 37 N·m (27 lb-ft). 5. Install leak-off lines (A) and T-fittings (B). Tighten nut to 5 N·m (3.5 lb-ft). A—Leak-off line B—T-fitting C—Cap screw D—Fuel injection line E—Carbon stop seal -UN-16JUN98 F—Seal washer G—Protection cap H—Protection cap J—Tube nut K—Rubber sleeve CD30675 -UN-20MAY98 CD30676 CD,CTM125,200 -19-01DEC97 40 63