OPERATING THE VEHICLE 20 B Coolant Temperature Gauge PARKING B Parking Brake Lever To avoid personal injury: A Do not remove radiator cap until coolant temperature is well below its boiling point. Then loosen cap slightly to the stop to relieve any pressure before removing cap completely. To avoid personal injury: BEFORE DISMOUNTING VEHICLE A ALWAYS APPLY THE PARKING BRAKE AND LOWER ALL IMPLEMENTS TO THE GROUND. Leaving transmission in gear with the engine stopped will not prevent from rolling. A STOP THE ENGINE AND REMOVE THE KEY. 1. With the key switch "ON" the temperature gauge indicates the temperature of the coolant. White Zone for "COLD" and Red zone for "HOT". 2.
If the indicator reaches the Red zone, engine coolant is overheated. Check the vehicle by referring to "TROUBLESHOOTING" section. 1. Stop the vehicle on a level surface. 2. To apply the parking brake, depress the brake pedal and pull the parking brake lever to park. 3. To release the parking brake, push the release button and push down the parking brake lever. When the parking brake is released, the brake indicator light in the Easy Checker(TM) goes off. (1) Coolant temperature gauge B Hourmeter The hourmeter indicates in 5 digits the hours the vehicle has been used; the last digit indicates 1/10 of an hour.
(1) Parking brake lever (2) Release button (A) "RELEASE" A If the vehicle is operated with the parking brake applied, the parking brake will be damaged. (1) Hourmeter