8 Mounting/removing front attachment 8.2 Installing the front attachment 67084 Pull out cotter pin (1) at (A). Slide lock pin (2) up into the opening of the feed rake conveyor of the machine, using lever (3). Secure lever (3) in this position, using a cotter pin (1). 3 A 1 2 19523 3 Checking / adjusting stop plates. - Install shims (1) on both sides between the stop plates (2) and the cutterbar frame and adjust the stop plates so that there is no lateral tension on the feed rake conveyor from either side. 1 2 4 19524 only front attachments and machines equipped with AUTO-CONTOUR: 4 Swing lever (1) up to position (A). Ensure that locking pin (2) engages in the bore of peg (4) of the machine.
Ensure that locking pin (2) is secured against twisting by locking pin (3). 1 A 3 2 5 24849 Repeat this procedure on the other side of the machine. 70765 8.2.3 Installing universal drive shaft Observe the general warnings at the beginning of the Fitting / removing the front attachment chapter. 128 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09