11 Fieldwork 11.6 Threshing mechanism 67087 Machine with standard wire concave For better disawning, up to two one-piece disawner bars can be installed in the main concave. R In the ex works condition, one one-piece bar with mat- ing bar is provided. Another one-piece bar (R) with a mating bar is enclosed with the machine. (accessory) When required, unscrew disawner bar (R) with mating bar from the stone trap cover. WARNING: 28507 25 Dirty concave. 1. L 2. R 3. Machine damage. Make sure surroundings are clean. Clean concave prior to installation. Ensure that the disawner bars make con- tact with the concave wires. 5 5 Bolt down the disawner bars (L, R) using 6 hex.
bolts M 8 x 25 DIN 933-8.8, contact washers A 8 and mating bar (5) for each bar. - Bolt on the left-ribbed disawner bar (L) between the 1st and 2nd concave bars. - Bolt on the right-ribbed disawner bar (R) between the 2nd and 3rd concave bars. F 26 19614 R L 27 16379 82332 11.6.5 Unslugging the threshing drum Observe the general warnings at the beginning of the "Fieldwork" chapter. L WARNING: Sensitive components surrounding the chisel. Machine damage. Make sure that the chisel does not dam- age the lubricating line and the speed sensor. Set the threshing concave downwards. Remove safety device. 19612 28 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09 209