13 Maintenance 13.5 Engine 67089 Environment! Lubricants and fuels end up in the environment. Environmental pollution. Lubricants and fuels must be collected and stored in suitable containers and dis- posed of in a way that is harmless to the environment and in accordance with existing anti-pollution regulations. Close the shut-off tap of the fuel system. Unscrew the filter pot (1) and remove the filter element. Wash the filter element and sight glass in diesel fuel and blow out with compressed air. WARNING: 1 Use of unpermissible spare parts or lubricants. Machine damage or increased wear.
17 Spare parts and lubricants must at least comply with the technical standards required by the manufacturer of the implement! The use of genuine CLAAS spare parts and lubricants is recommended. Standard equipment 29516 Insert filter element and fit filter pot (1). Make sure the seal is properly fitted! Replace damaged seals! Open the shut-off tap of the fuel system. Bleed fuel system. 1 18 Accessory 29517 86100 13.5.12 Draining condensation at the fuel pre- filter (standard equipment) The fuel pre-filter is accessible after opening the right- hand side panel. Any water contained in the fuel is collected in the sight glass.
As soon as the drain plug (2) has been loosened, drain the accumulated amount of water and col- lect it in a container. Observe the general warnings at the beginning of the "Maintenance" chapter. 284 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09